How To Change Ignition Switch On 1989 Chevy Truck




How To Change Ignition Switch On 1989 Chevy Truck

Article Navigation:
  • Photo
  • Ignition Switch | O'Reilly Auto Parts
  • Video
  • RELATED PAGES
  • how to replace key swicth in the ingnition - Chevrolet Pickup. Start the truck to ensure the ignition switch is functioning correctly. I have a chevy pick AUTOBOARDZ.COM screws AUTOBOARDZ.COM 1 bolt holding wheel & the.

    How do you replace the ignition switch on a chevy c silverado truck. I went to start my truck last night and nothing happened, so I.

    How to Rekey a ‐ Chevy Truck Ignition Cylinder Lock. To re-key the lock cylinder you must remove the assembly from the steering column. If it is a.

    How To Change Ignition Switch On 1989 Chevy Truck

    How To Change Ignition Switch On 1989 Chevy Truck

    To re-key the lock cylinder you must remove the assembly from the steering column. I am having the same troubles with my 98 Silverado. Yes the steering wheel and lock plate must be pulled. I also cannot figure out if I got the actuator turned improperly it is now pointing up. Whether it is a standard or tilt wheel, the steering wheel needs to come off.

    How To Change Ignition Switch On 1989 Chevy Truck

    How To Change Ignition Switch On 1989 Chevy Truck

    How To Change Ignition Switch On 1989 Chevy Truck

    How To Change Ignition Switch On 1989 Chevy Truck

    How To Change Ignition Switch On 1989 Chevy Truck

    key switch replace or repair - Chevrolet Pickup - iFixit

    Need to replace ignition switch on my 89 chevy truck I broke my key off in it and I need a need a new one. Ignition lock cylinder needs removed. To do so, perform following operations. Remove the steering wheel. Remove the turn signal switch. It is not necessary to completely remove the switch from the column.

    Pull the switch rearward far enough to slip it over the end of the shaft, but do not pull the harness out of the column. Turn the lock to Run. If necessary, remove the ignition key. If equipped, remove the buzzer switch assembly. Remove the lock retaining screw and remove the lock cylinder.

    How To Change Ignition Switch On 1989 Chevy Truck

    Rotate the key to the stop while holding onto the cylinder. Push the lock all the way in. Tighten the screw to 40 inch lbs. Install the turn signal switch and the steering wheel. He is correct but he is talking about the ignition switch, you are talking about the ignition lock cylinder. You will have to disassemble part of the steering column.

    If you don't have a gm lock plate remover you will want to rent 1. If you need instructions on how to do it let me know and I will walk you through it. Sorry about that, I edited above post to removing lock clyinder, not switch.

    How To Change Ignition Switch On 1989 Chevy Truck

    Thanks for using 2CarPros. No problem, I worked in parts for a long time and many people mistake the two of them. Good luck, let me know if you need more info. The car pro guy is correct but he left out the lock plate removal, you have to compress the plate and spring then remove the retaining clip.

    Please login or register to post a reply. Asked by wsmith yahoo. Ask a Car Question.

    How To Change Ignition Switch On 1989 Chevy Truck

    Replace ignition switch Chevy Truck / Suburban 1500



    • Подписаться по RSSRSS
    • Поделиться VkontakteVkontakte
    • Поделиться на FacebookFacebook
    • Твитнуть!Twitter

    Leave a Reply

    Return to Top ▲TOP ▲